Bottom mount your turbo with this engine bracket!
- Keep your Air Conditioning!
- Keep your Secondary Air system!
- Keep your Windshield Washer Fluid Reservoir!
- Keep Excessive Heat Away From Your Valve Cover, Headlight, and Hood Insulation!
- No Paint Blistering on your Hood!
- Keep your Center of Gravity Low, and Better Weight Distribution!
- Can be used to Keep your Car Emissions Legal in Most States! (With proper tune and catalytic converter. Check your local laws for legality before purchase.)
Our team of engineers at Long Island Supercars have designed a perfect solution for bottom mounting a single turbo in your rear wheel drive BMW E46. These engine brackets are now in production and in stock. This engine bracket can support up to a 4 inch inlet turbo and the 4" K&N filter is included. This engine bracket is the key component in our 1088HP daily driven M52B28 E46. Estimated power capability of this bracket is over 1500HP.
Made of thick steel to exact specifications to be a direct bolt on for any RWD E46. The 4" pass through inlet pipe is designed to be a structural component of the mount giving it superior rigidity and to be able to handle any amount of power you can throw at it. We recommend using urethane or solid engine mounts, but this bracket has plenty of clearance for the factory rubber mount. The air filter tucks nearly behind the A/C compressor and above the subframe. The engine bracket and air filter can easily be installed without moving the engine or removing the subframe. The length of the 4" pass through inlet tube is sized perfectly to allow easy access to the air filter clamp for easy removal for cleaning and maintenance.
You can easily bottom mount up to a GT35 turbo with this bracket and using the inexpensive T3 cast iron manifolds on the market. There is enough room to squeeze up to a GT45 turbo down low with a custom built manifold.
Does not fit AWD (Xi) or right side drive models. Professional installation recommended. No installation instructions included as this is engineered to be a direct bolt on replacement to the factory cast aluminum engine bracket. During installation, proper engine support with an engine support bar between the fenders is required.
Included in the package:
- Engine bracket
- K&N 4" Inlet Air Filter